Spending a Day With Energy Policy Geeks

first_imgI recently attended a small, one-day meeting in Atlanta of individuals and organizations involved in energy efficiency throughout the southeast U.S. Hosted by SEEA, the Southeast Energy Efficiency Alliance, the group responsible for distributing much of the ARRA money for efficiency throughout the region.Along with the typical discussions of successes and challenges (or failures) in the region, there were a few standard utility company party-line comments and, somewhat surprisingly, a few off-the-wall comments that suggested a little bit of revolutionary thinking going on in the industry.Opening act: the sky is fallingThe morning keynote address was given by Dr. Marilyn Brown of Georgia Tech and Oak Ridge National Laboratory, who is the author of too many books and reports on energy to mention. Although her slides were almost illegible, she presented some pretty frightening statistics including her calculations that we have used up our carbon budget and only have about five years left to change our direction before climate change takes an irreversible course to someplace we don’t want to go.Since 2005, per capita U.S. energy use has decreased, primarily because the most energy-intensive industries are now mostly in other countries.Finally, addressing our regional audience, the southeast US has about 36% of the country’s population but uses 44% of total energy generation. What a lovely way to start the day.Rethinking public policiesThe most interesting information came out of two panel discussions. The morning session included a discussion of how public policy affects energy industry decisions. The moderator started with a review of current public policy: Electric utilities should produce reliable power at the lowest cost to the consumer; and a potential alternate policy to consider: Electric utilities should produce reliable power at the lowest cost to the environment. Kind of mind-blowingly simple concept, but changing core public policy is not easy, especially when it would likely increase energy costs to the end user.There was a good discussion on renewable energy standards, few of which currently exist in the southeast. North Carolina, one of the few states with a standard, is required to provide 12.5% of its energy from renewable sources by 2021, which has been calculated to cost $34 annually per household – a surprisingly reasonable cost.One panelist suggested that utilities should just charge all their customers for efficiency programs and then ask them if they want to take advantage of them. There’s something about that idea that appeals to me.There was a good discussion of how to effectively finance energy efficiency programs, including on-bill financing. It was pointed out that nationally, the default rate on power bills is 3/10 of 1% – seems like a great place to finance energy efficiency and renewable energy projects.A discussion of time-of-use dynamic pricing was interesting. Some utilities that have tried it were not successful because customers didn’t want to think about it. The consensus was that customers don’t want to make decisions on their power purchases.Duke Energy found that dynamic pricing led to overcharging for peak and undercharging for off peak power to provide enough incentive for customers to change their behavior. Utility managed controllers on HVAC and water heating equipment tends to work better to reduce peak loads.Getting efficiency doneThe afternoon panel included the director of the Charlottesville, Virgina, efficiency program; a developer from New Orleans; the Nashville, Tennessee director of sustainability; and a representative from Duke Energy, discussing the challenge of financing energy efficiency improvements.New Orleans has a program (supported by grant money) that provides financing for less than 4%. Non-subsidized loan programs find it almost impossible to get rates below 6%, due to administrative costs on small loans.Duke Energy threw out one of the best wild ideas of the day – a concept they are working on but have not yet implemented – offering a fixed monthly total bill to their customers based on historical costs. Not a fixed rate, but an actual fixed amount they will pay per month. They believe that it is possible to calculate a figure for each customer that will allow them to include the cost of performing efficiency improvements to a building in a monthly bill while still making a profit and lowering demand. If utilities were to do this, they would have an incentive to do improvements that really work, as they would benefit directly from good work and suffer from poor work.Probably my favorite comment of the day came towards the end of the afternoon panel. It was suggested that utilities should be able to withhold energy from inefficient buildings to help cut demand and incentivize people to improve their efficiency. Now, I don’t think anyone was seriously considering implementing this policy, but it was refreshing to hear uncensored, creative thinking, particularly from usually staid utility companies. I hope that some of the wild ideas I heard help move things forward in the not-too-distant future.last_img

Leave a Reply